Differences

This shows you the differences between two versions of the page.

--- runningthegeneratedequipmentsimulator [2021/08/28 16:01] – wikiadmin
+++ runningthegeneratedequipmentsimulator [2021/09/02 13:38] (current) – wikiadmin
@@ Line 46: / Line 46: @@
 Any file generated by TransSECS GEM Host will work. This file describes the tool and so can be used as a basis to reproduce the behavior of the tool.
-This JSON file can be loaded into a bare simulator.  You can use the GEMTool example for this, or download the SimulatorTool from [[https://ergotech.com/files/examples/SimulatorTool.zip|here]] (this is just the GEMTool example with CEIDs and the simulation specific VIDs removed).
+This JSON file can be loaded into a bare simulator.  You can use the GEMTool example for this, or download the SimulatorTool from [[https://ergotech.com/files/examples/SimlatorTool.zip|here]] (this is just the GEMTool example with CEIDs and the simulation specific VIDs removed).
 Edit the ToolSimulator.conf file in the MIStudioSuite\TransSECS\resources\ToolSimulator folder
@@ Line 95: / Line 95: @@
 Change the //Device ID// and //Port// in the file to match the values in your host.  You can see what you've set in your host by clicking on the root of the tree.
-{{:pasted:20210828-145027.png?0x300}}
+{{:pasted:20210828-145027.png?0x100}}
 Modify and uncomment the appropriate lines in the .conf file:
@@ Line 122: / Line 122: @@
 Build your host application, click the SIM/LIVE button and click on a message.  You'll see it connect to the simulator:
-{{:pasted:20210828-144539.png}}
+{{:pasted:20210828-150432.png}}
 Choose an event and press the "Send Event" button.  If you have reports attached to the event, choose a VID, change the value, send the event again and you'll see the updated value.